Class 3. Metric Supplement Required
We have found that a major portion of firms supplying
Requires existing pre-printed literature to be
submittal data already have their data available in either
supplemented to show conformance with requirements
metric only or dual dimensioned format.
stated in the specification or on drawings.
Supplements can be:
We can provide sample acceptable submittals to
government agencies for virtually any product.
1. Bond Paper Supplement
2. Handwritten Or Typed On Existing Literature
3. Other Approved Method
Steel Deck Data
The entire product literature does not need to be
converted, only those numbers sufficient to show that the
sizes submitted are those sizes required (such as 38 mm,
etc). The bond paper supplement would state the 1.5 inch
deck is equal to 38 mm.
Epoxy Adhesive Literature must only show conformance
with requirements specifically shown in the specs.
Preprinted Mechanical / Electrical Equipment Catalogs
need not be converted. However, conformance with
specified and scheduled flowrates, pressures,
temperatures, thermal output rates, etc, must be
Physical dimensions of mechanical and electrical
equipment shown on project specific installation
drawings are Class 1, and must show metric only.
Typical eqpmt: Boilers, AHUs, Chillers, Terminal
Units, Pumps, Exhaust Fans, Switchgear, Pumps,
. Elevator Component Data
. Bathroom Component Details
. Mini-Blind Data
. Roof Hatch Sizes
. Metal Ceiling Grid Data
. Access Floor Tile Data
. Plumbing Fixture Data
. Metal Stud Data
. Structural Bolt Data
. Paint Literature
. Formwork Release Agent Data
. Valve, Pipe, and Fittings Data